HSE type is the exclusive control panel which can control the operation interval of soft disk blaster and knocker. Input power supplies 100V/200V, and it is only for indoor.

HKE type can control of the operation interval of soft disk Blaster and knocker. Furthermore, an solenoid valve is equipped and A lines and B 2 set operations are possible. (1 set of operations is possible for HSE) Input power supply has 100V / 200 V series, and HKE5000 series only for the outdoors.HKE1000 series is　only for indoor.

※Please refer to the「Flow aid equipment combination」

10 solenoid valve can be operated simultaneous (HSE type)

Maximum of 10 simultaneous operations of the solenoid valve which controls knocker is possible. Effective, when controlling many knockers by the one site.

Timer set period can choose for 0.5 sec to 300 h (HSE type)

It is controllable for knocker operation set-period (off-timer) a maximum of 300 hours. Setup of a wide operation interval is possible, it can respond at intervals of any operations in almost all the site.

Clear in a protection level IP44(HKE5100/5200)

HKE5100/5200 types are protection level(IP44) , waterproofing, dustproof structures, use out or indoor is possible. It can install without choosing the site, such as the dusty spot and installation at the outdoors.

Two or more set use is possible (HKE type)

RKV/RKD/RKVS30PA the number of knocker use (Usually of piping) is 8 sets. 40/60PA is 6 sets. 4 sets of simultaneous control are possible for 80/100PA.(per set) (It is not concerned with a model at the time of relay piping, but it can be used to 10 per set)

The signal from external equipment also operational

The external contact point (non-voltage contact) currently installed in the terminal stand is used in a distribution power board. Since a knocker's strike can be made to start in response to the signal of the opening-and-closing valve of a hopper, and the signal of a conveyance line, it is convenient for the remote control at the time of automatic control.